News & Insights | Datian Machine

Project Reference

Green Guard VRU in the Field: Red Sea, Saudi Arabia

Installed and commissioned with our partner Tamkeen Mobility at a coastal fuel station — live HMI shows vent-stack VOCs at 0 g/m³, well below the 2 g/m³ limit.

Read the project story → See it on the Green Guard page

Full Workshop: G & T Series Dispensers in Production

18 October 2026

G Series, T Series at 80 and 120 LPM and high-flow 200-300 LPM units moving down the Datian workshop floor - built with our own CP8 pumps and J6 meters, flow-tested before packing.

Bennett Replacement Parts: Pumps, Flow Meters, Solenoid Valves and Sensors

9 October 2026

Datian builds the pumps, flow meters, solenoid valves and sensors inside fuel dispensers, and was the Chinese partner in Bennett's Shanghai joint venture.

Red Jacket STP Replacement: Whole Assembly or Motor Only

9 October 2026

A Red Jacket STP replacement takes one of two shapes: swap the whole DT-STP assembly, or change the motor end only. Here is what decides which applies.

Inside the T-Series Dispenser: CP8 Pump, J6 Meter and the Flow Test

4 October 2026

Inside a T-series dispenser being assembled: our own CP8 high-flow pump, J6 flow meter, solenoid valve and pulser, flow-tested at 110 and 125 L/min.

Vapor Recovery Membrane Test: Measured Tail-Gas Concentration at Five Flow Rates

30 September 2026

A Green Guard separation membrane was fed 700 g/m³ gasoline vapor; the tail gas measured at 3.5 to 4.5 m³/h stayed below 5.1 g/m³ at every flow rate.

Same Machine, Your Brand: OEM DT-G Fuel Dispensers

26 October 2026

These DT-G dispensers just finished assembly in our Wenzhou factory. Look at the badge on the cabinet in the photo below — that is our own Datian Fueling logo, and it is worth explaining.

Looking for a specific product?

Send us your requirements and we will match the right dispenser, pump or meter to your site.

Get a Quote All Products